Charging Rechargeable Batteries With Balancer Connection ("Balance") - VOLTCRAFT V-CHARGE 100 DUO Notice D'emploi

Various information is indicated on the display during a charge/discharge process by
repeatedly pressing the button "DEC" (see chapter 20). If you do not push any button
for a few seconds, the charger will return to the normal display.
• After completion of charging, an audio signal is emitted (if it has not been turned off).
If you wish to cancel the charging process, push the "BATT. TYPE/STOP" button.
c) Charging Rechargeable Batteries with Balancer Connection
("BALANCE")
In contrast to the simple rechargeable battery programme
"CHARGE" (see chapter 11. b), the rechargeable battery
programme "BALANCE" motors the voltage of every sin-
gle cell of a multiple-cell lithium rechargeable battery and
corrects it accordingly if there are any deviations.
Besides the two normal rechargeable battery connections (plus/+ and minus/-), the balancer
connector for the battery must also be connected to the charger.
Observe correct polarity when connecting the balancer plug of the rechargeable battery to the
charger. Usually, the minus pole of the balancer connection is applied with a black cable or is
specifically marked. This side of the balancer plug must point in the direction "-" of the charger's
balancer socket and of course also be pushed onto this connection pin.
If you use self-customised rechargeable batteries, the balancer plug must be correctly
assigned.
The black/marked cable is the minus pole of the first cell. The next connection pin is
the plus pole of the first cell; the respective next connection pin is the plus pole of the
second, third, fourth, fifth and sixth cell (depending on cell number).
The last connection pin of the balancer plug of the rechargeable battery therefore is
the plus pole of the last cell. Therefore, the same voltage can be measured between
the two outer pins of the balancer plug as at the two rechargeable battery connections
directly.
The remaining procedure for charging is described in chapter 11. b).
If a lithium rechargeable battery with balancer plug is con-
nected to the charger, you can switch to the display of the
individual cell voltages by pushing the button "INC", see
figure on the right.
Briefly push the button "START/ENTER" for the charger to return to the normal display.
LiPo BALANCE
2.0A 7.4V(2S)
3.90 3.92 3.89 V
0.00 0.00 0.00 V
85