Assembly Instructions; Expanding The Feet; Installing The Regulator Valve; Attaching The Lid Handle - Pit Boss PB100P Instructions Et Utilisation

1.

EXPANDING THE FEET

Parts Required:
1 x Firebox Assembly (#1)
Installation:
• Place the firebox on a clean, level
surface, thermometer on the top.
Tip the unit backwards and extend
the feet until they lock into position.
2.

INSTALLING THE REGULATOR VALVE

Parts Required:
Regulator (#3)
1 x
Installation:
• Insert the end of the regulator valve
into the opening on the side of the
firebox. Hand-tighten by rotating
the part clockwise until completely
secured into the opening.
3.

ATTACHING THE LID HANDLE

Parts Required:
Lid Handle (#2)
1 x
Installation:
• Remove the pre-installed screws
from the lid handle. From inside
the barrel lid, insert one screw to
protrude to the outside. Hand-
tighten the screw (from the inside)
into the lid handle. Repeat same
installation for other end of lid
handle. Secure using tool.
• The unit is now assembled.

ASSEMBLY INSTRUCTIONS

7