Intended Use Of This Power Tool; Prohibited Use Of This Power Tool; Safety Precautions; Electrical Safety - Evolution FURY3 STEALTH 030-0006 Instructions D'origine

INTENDED USE OF THIS
POWER TOOL
WARNING:
This product is a Multipurpose
Sliding Mitre Saw and has been designed to
be used with special Evolution Multipurpose
blades. Only use blades designed for use in
this machine and/or those recommended
specifically by Evolution Power Tools Ltd.
WHEN FITTED WITH A CORRECT
BLADE THIS MACHINE CAN BE
USED TO CUT:
• Wood, Wood derived products (MDF, Chipboard,
Plywood, Blockboard, Hardboard etc),
• Wood with nails,
• 50mm mild steel box section with 4mm wall at
HB 200-220,
• 6mm mild steel plate at HB 200-220.
Note: Wood containing non galvanised nails or
screws, with care, can be safely cut.
Note: Not recommended for cutting galvanised
materials or wood with embedded galvanised
nails. For cutting stainless steel we recommend
Evolution dedicated stainless steel blades.
PROHIBITED USE OF THIS
POWER TOOL
WARNING:
This product is a Multipurpose
Sliding Mitre Saw and must only be used as
such. It must not be modified in any way,
or used to power any other equipment or
drive any other accessories other than those
mentioned in this Instruction Manual.
(1.13)
WARNING:
This product is not intended for
use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been
given supervision or instruction concerning the
safe use of the product by a person responsible for
their safety and who is competent in its safe use.
www.evolutionpowertools.com
(1.14)

ELECTRICAL SAFETY

This machine is fitted with the correct
moulded plug and mains lead for the
designated market. If the supply cord is
damaged, it must be replaced by a special
cord or assembly available from the
manufacturers or its service agent.
(1.15)
OUTDOOR USE
WARNING:
For your protection if this tool is
to be used outdoors it should not be exposed
to rain, or used in damp locations. Do not place
the tool on damp surfaces. Use a clean, dry
workbench if available. For added protection
use a residual current device (R.C.D.) that will
interrupt the supply if the leakage current to
earth exceeds 30mA for 30ms. Always check
the operation of the residual current device
(R.C.D.) before using the machine.
If an extension cable is required it must be a
suitable type for use outdoors and so labelled.
The manufacturers instructions should be
followed when using an extension cable.
(2.1) POWER TOOL GENERAL
SAFETY INSTRUCTIONS
WARNING:
When using electric tools basic
safety precautions should always be followed to
reduce the risk of fire, electric shock and personal
injury including the following.
Note: This power tool should not be powered on
continuously for a long time.
WARNING:
Read all safety warnings and
instructions before attempting to operate this
product and save these instructions.
Failure to follow the warnings and instructions
may result in electric shock, fire and/or serious
injury.
10