Dometic SP950C Instructions De Montage page 19

CoolAir SP950C/SPX1200C
• Avoid any narrow radiuses when routing and bending supply lines. Use a
suitable round object with a shim as a bending aid. A radius which is too
narrow will kink the refrigerant line, and this will prevent the auxiliary air
conditioning unit from operating.
➤ Shorten any supply line which is not needed by bending a curve.
➤ Apply sealant (fig. 8 1, page 8) to prevent any water from getting between
the rear wall of the truck and the clip.
I
NOTE
If you want to avoid damaging the rear wall of the truck (drilling a hole), you can
also apply the clip using a suitable adhesive.
Observe the instructions provided by the adhesive manufacturer.
➤ Use the supplied holders to fasten the connection line to the rear panel of the
truck (fig. 8, page 8).
➤ Insert corrugated piping in the holder provided (fig. 8 2, page 8).
➤ Put on the lid (fig. 8 4, page 8).
➤ Insert the plug of the cable (power cable) into the mating plug of the
compressor unit (fig. 9, page 9).
➤ Insert the plug connection of the fan cable back together.
➤ Place the outer housing onto the compressor unit.
➤ Fasten the outer housing with the eight hexagon socket screws (fig. 2 2,
page 4).
➤ Fasten the fan with the four hexagon bolts (fig. 2 1, page 4).
EN
Installation
19