Installing The Compressor Unit - Dometic SP950C Instructions De Montage

CoolAir SP950C/SPX1200C
6.4

Installing the compressor unit

A
NOTICE!
Due to its weight, the compressor unit must have contact with at least two
fastening points of the fastening surface. Do not use spacer sleeves for all four
fastening points.
I
NOTE
To install the compressor unit using a vehicle-specific fastening frame, please
observe the instructions included in the frame's scope of delivery. The
following work steps describe the installation of the compressor unit without
vehicle-specific fastening frame.
➤ Dismantle the outer housing.
To do this, remove the four hexagon bolts on the fan (fig. 2 1, page 4) and
the eight hexagon socket head bolts (fig. 2 2, page 4).
When taking off the outer housing, release the plug connection of the fan
connection cable.
➤ Decide on the position of the compressor unit.
Use the fastening holes of the compressor unit as a template.
➤ Use a felt pen to mark the positions selected for the holes.
➤ Drill fastening holes (Ø 9 mm) at the marked positions.
I
NOTE
Apply anti-oxidant compound to all drilled through-holes to prevent rust
formation.
➤ Push the four M8 x 40 mm bolts (fig. 3 10,page 5) with the four washers
outer diameter Ø 40 mm (fig. 3 9,page 5) from the inside through the rear
wall.
➤ From the outside, push the four washers (fig. 3 8,page 5) on the protruding
bolts.
➤ Fasten the bolts and washers using the narrow M8 bolts (fig. 3 7, page 5).
➤ Push the washers (fig. 4 6, page 6) on the protruding M8 bolts.
For rear walls with an offset, use the supplied spacer sleeves (fig. 4 5,
page 6) to compensate.
Adjust the length.
➤ Put the compressor unit on the protruding M8 bolts.
➤ Fasten with the M8 washers (fig. 4 4, page 6) and the M8 lock nuts
(fig. 4 3, page 6).
EN
Installation
17