Rizzoli RE - RVE Série Manuel D'utilisation page 97

Cuisinière a bois
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

4
MAINTENANCE
4.1
CLEANING
The cooker works better if all its parts are without
combustion residuals, a clean cooker will be less
exposed to problems due to wear. Cleaning fre­
WARNING! All these operations must be done with cold kitchen.
4.2
CLEANING THE VISIBLE PARTS
Stainless steel parts have to be cleaned cold with
neutral detersives or with a specific solution for
stainless steel in case of hard to remove dirt. Do
not use at all abrasive sponges that may scratch
the surface. Dry with a soft rag, following the glaz­
ing wise.
In particular situations, after the installation or
with the cooking of meals, an oxidised superfi­
cial stratus may be generated, in particular on the
inox stainless steel frame. Also in these situations,
4.3
GRILL CLEANING
Every time you use the cooker you have to clean
the wood carrying grill before, at least you have
to clean the more rough deposits: the holes of the
grill should not be obstructed. To make this you
can use the poker given together with the cook­
4.4
ASH BOX
Every time you use the cooker you have to check
the ash box located under the combustion cham­
ber. When the box is full, you have to empty it.
If you do not empty it, the ash accumulates itself
quency depends on how much and how the cooker
is used, as well as on combustible quality.
an accurate cleaning will restore the state of the
product as it was new.
On request Rizzoli gives specific products to clean
stainless steel. For enamelled or painted parts, do
not use abrasive or aggressive solution and in case
of stains pour some oil and wait while it absorbs
the halo, then clean with a soft rag. It is also rec­
ommended to avoid the use of solvents or dena­
tured alcohol on painted parts.
er. If the grill is not well cleaned, the flame could
not be well feed and so you could experience an
irregular combustion. If the grill is being removed,
it must be placed in its housing with the flat part
turned upwards.
and makes the cleaning more difficult. In case of
excessive cinders the flame could not be well fed
and you could experience an irregular combustion.
95

Publicité

Chapitres

Table des Matières
loading

Table des Matières