Rizzoli RE - RVE Série Manuel D'utilisation page 81

Picture 11 - Flue outlet on the side. Fixed connector for the flue outlet on the side.
The connection with the chimney must be always
well fixed and sealed, it must not have narrowing
and must not decrease the usable section of the
chimney (see picture 12). If near the cooker there
NO
Picture 12 - Examples of correct and incorrect connection of the chimney.
2.12 ADJUSTABLE REAR FLUE OUTLET (COOKERS WITHOUT OVEN)
On each model without oven it is possible to
change the position of the flue outlet from right to
left and vice versa. Moreover, it is possible also to
change the horizontal and vertical position in or­
der to connect more easily the pipe to the chimney
hood. For the horizontal regulation, it is necessary
to unscrew the 8 screws sustaining the external
sheet and then screw again them when the flue
outlet is in the chosen position. To vary the flue
outlet from right to left remove and tilt the sheet,
is inflammable material or high temperatures sen­
sible, the connection must be isolated and the
safety distances must be strictly observed.
NO NO
then fix it. On demand, Rizzoli can provide an extra
sheet to be used in the intermediate positions of
the sheet (see picture 13b). For both the horizontal
and the vertical regulations there is a tolerance of
1 cm thanks to the provided bayonet fitting as de­
scribed in paragraph 2.11.
In the following tables are reported the minimum
and maximum dimensions (in mm) of the distances
from the centre of the hole of the rear flue outlet
from the external side of the frame.
79
YES