Charging Process - Grizzly AGS 108 Lion Traduction De La Notice D'utilisation Originale

GB
• Do not operate the charger
on a combustible surface
(e.g. paper, textiles). Risk
of fire due to heating during
charging.
• If the power cable for this
equipment is damaged, it
must be replaced by the
manufacturer, a customer
service agent of the same or
a similarly qualified person
in order to prevent hazards.
• Do not use the charger to
charge non-rechargeable bat-
teries.

Charging process

Do not expose the battery to
extreme conditions such as heat
and impact. There is a risk of
injury from leaking electrolyte
solution! In case of contact,
rinse with water or neutraliser
and consult a doctor if contact
has occurred with eyes etc.
Charge the battery only in dry
areas.
There is a risk of injury from
electric shock.
The device may only be powered
with SELV as marked on the device.
Ensure that the equipment is
charged for no longer than
3-5 hours without interruption.
The battery and equipment could
be damaged and they consume
energy unnecessarily in case of
longer charging time. Overcharg-
ing invalidates the guarantee.
78
• Before initial use, charge the battery
installed in the equipment. Do not
charge the battery for several short
periods in succession.
• You should use the battery charger
supplied to charge up the Li-ion bat-
tery inserted in the device.
• Recharge the battery if the equipment
runs too slowly.
• In all cases, observe the applicable
safety information as well as the regu-
lations and directions for environmen-
tal protection.
• Defects resulting from improper han-
dling are not subject to the guarantee.
Signals of the LED charging indicator
(6a):
no indicator
green
red
green flashing
red flashing
slowly
red flashing
quickly
1. Insert the battery (7) into the
retainer of the device. This is
located at the end of the handle
(4).
2. Connect the charger cable plug
(17) with the charger socket on
the tool (5b).
3. Connect the power supply unit
(16) to a socket.
The charging indicator (6a) lights
up:
Red: Equipment charging.
Green: Charging finished.
The recommended charging
normal operation
fully charged
battery is charging
battery low, charge!
allow to cool down -
device overheated!
Battery defective,
insert new battery!