Overview; Charging Process - Grizzly AGS 720 Lion-Set Traduction De La Notice D'utilisation Originale

Overview

Equipment:
1 Operating / charging indicator
2 Cutter head
3 Lever to turn the cutter head
4 Unit handle
5 Plug socket for plug connection
telescopic arm
6 Safety key
7 Charging socket
8 On/off switch, unit
9 Port for telescopic handle
10 Switch lock, unit
11 Release switch telescopic shaft
12 Blade cover
13 Wheels with axle
Telescopic arm with wheels:
14 Handle
15 On/off switch, telescopic shaft
16 Switch lock, telescopic shaft
17 Telescopic tube
18 Adjusting screw for length ad-
justment
19 Plug connection
20 Switch lock for turning the te-
lescopic shaft.
Battery charger:
21 Recharger cable plug
22 Power supply unit
Cutter:
23 Shrub shear blade
24 Blade guard for shrub shear
blade
25 Grass shear blade
26 Blade guard for grass shear
blade
27 Blade mounting key

Charging process

Do not expose the battery to
extreme conditions such as heat
and impact. There is a risk of
injury from leaking electrolyte
solution! In case of contact,
rinse with water or neutraliser
and consult a doctor if contact
has occurred with eyes etc.
Do not switch on the device
while charging it and make sure
that the safety key (
been removed.
There is a risk of injury from
electric shock.
Charge the battery only in dry
areas.
There is a risk of injury from
electric shock.
The device may only be powered
with SELV as marked on the device
• Before initial use, charge the battery
installed in the equipment. Do not
charge the battery for several short
periods in succession.
• You should use the battery charger
supplied to charge up the Li-ion bat-
tery inserted in the device.
• Recharge the battery if the equipment
runs too slowly.
• In all cases, observe the applicable
safety information as well as the regu-
lations and directions for environmen-
tal protection.
• Defects resulting from improper han-
dling are not subject to the guarantee.
GB
6) has
125