Reaction Of The Code Lock To Incorrect Entries - Renkforce 1582597 Notice D'emploi

To enable this mode, proceed as follows:
3 2 8 9
*
4 2
#
*
43 + # = Toggle mode with shorter opening code (3 digits)
With this setting, the relay is activated when the first three digits of the user code are recognized
by the code lock. The complete user code must be entered to disable the relay and enable
standby mode. Each additional entry of the first three digits or complete user code switches
between these two states.
3 2 8 9
*
4 3
#
*
k) Reaction of the code lock to incorrect entries
70 + 00 + # = No key lock
3 2 8 9
*
Enter the master code (in this example, the master code is "3289")
to enable programming mode, and then press the * key. The code lock
will beep twice and the yellow LED will stay constant to indicate that
programming mode is enabled.
Enter the memory code "42".
Press the # key to confirm your entry. The code lock will beep twice to
confirm that the setting has been saved.
If the entry was incorrect or unsuccessful, the code lock will beep and the
yellow LED will flash five times.
Press the * key to exit programming mode. The yellow LED will start to
flash again.
Enter the master code (in this example, the master code is "3289")
to enable programming mode, and then press the * key. The code lock
will beep twice and the yellow LED will stay constant to indicate that
programming mode is enabled.
Enter the memory code "43".
Press the # key to confirm your entry. The code lock will beep twice to
confirm that the setting has been saved.
If the entry was incorrect or unsuccessful, the code lock will beep and the
yellow LED will flash five times.
Press the * key to exit programming mode. The yellow LED will start to
flash again.
Enter the master code (in this example, the master code is "3289")
to enable programming mode, and then press the * key. The code lock
will beep twice and the yellow LED will stay constant to indicate that
programming mode is enabled.
65