Renkforce 1582597 Notice D'emploi page 64

4 0
3
#
*
41 + # = Toggle mode
With this setting, the relay stays activated when the correct user code is entered. The user code
must be entered again to disable the relay and enable standby mode. Each additional entry
switches between these two states.
4 1
#
*
42 + # = Toggle mode with shorter opening code (2 digits)
With this setting, the relay is activated when the first two digits of the user code are recognized
by the code lock. The complete user code must be entered to disable the relay and enable
standby mode. Each additional entry of the first two digits or complete user code switches
between these two states.
The shorter code and complete code function like two user codes with different
functions. The shorter code can be only be used to activate the relay; the full code
is required to disable it. This mode can be used to enable staff to open a door or
activate an alarm system and ensure that only a manager is able to disable the relay
by entering the entire code.
The superuser code can be used at any time to enable/disable the relay. For more
information, see c) "Activating the relay with the superuser code (opening/closing)" in
section 11 ("Operation").
64
Enter the memory code "40".
Enter the activation time in seconds. In this example, the activation time
is 3 seconds.
Press the # key to confirm your entry. The code lock will beep twice to
confirm that the setting has been saved.
If the entry was incorrect or unsuccessful, the code lock will beep and the
yellow LED will flash five times.
Press the * key to exit programming mode. The yellow LED will start to
flash again.
Enter the memory code "41".
Press the # key to confirm your entry. The code lock will beep twice to
confirm that the setting has been saved.
If the entry was incorrect or unsuccessful, the code lock will beep and the
yellow LED will flash five times.
Press the * key to exit programming mode. The yellow LED will start to
flash again.