Programming A User Code - Renkforce 1582597 Notice D'emploi

0 0 0 0
*
0
3 2 8 9 #
*
If you forget the master code, you can only enable programming mode by using the
"DAP" jumper. Refer to section 12 ("DAP jumper") for details. Program a new master
code as described above. The old master code will be deleted.
e) Programming a user code
User codes are used to activate the relay for a door opener. You can save up to 100 codes for
different users. Each user code is assigned to a user ID from 00 to 99. Memory slot 1 saves the
user codes. To program user codes, follow the instructions below.
1 + [user ID 0 to 99] + [user code] + # = User code to open the door
To program a user code, press the keys in the order shown in the left-hand diagram. Follow the
instructions on the right-hand side.
3 2 8 9
*
Enter the master code (in this example, the master code is "0000", the
factory default setting) to enable programming mode, and then press the *
key. The yellow LED will stay constant to indicate that programming mode
is enabled.
Enter the memory code "0". Set the new master code to "3289". Press the
# key to confirm your entry.
Press the * key to exit programming mode. The yellow LED will start to
flash again.
Enter the master code (in this example, the master code is "3289")
to enable programming mode, and then press the * key. The code lock
will beep twice and the yellow LED will stay constant to indicate that
programming mode is enabled.
59