Yellow Led (3); Green Led (4); Backlight - Renkforce 1582597 Notice D'emploi

b) Yellow LED (3)
Together with the buzzer, this LED is a confirmation/function LED indicator. If a code is entered
without pressing the * key (star key) or # key (hash key), and no other button is pressed for 10
seconds, the code lock will beep and the yellow LED will flash five times. All previous entries
will be reset, and you will need to repeat the entry. The maximum time for entering a code is
30 seconds.
Status
Program mode
Key press (confirmed)
The entered code is correct
The entered code is not
correct
DAP jumper is set to "ON"
Standby
Relay is activated
The beep sounds can be enabled/disabled (memory slot 83). This does not affect the
beep sounds for the door opener connected to the "EG IN" terminal (7), which are
programmed separately (memory slot 81).
c) Green LED (4)
The relay was activated by entering a code. The activation time depends on the settings (1 to
999 seconds, or switch/toggle mode).
d) Cancelling an entry
To cancel an entry (e.g. after entering an incorrect code), press the * key (star key) or # key
(hash key). The code lock will beep and the yellow LED (3) will flash five times. All previous
entries will be reset; you can then repeat the entry.
e) Backlight
The keypad backlight is dimmed in standby mode. When a key is pressed, the brightness is
automatically increased for 10 seconds, indicating the remaining time for entering a code after
the previous entry. The yellow LED will flash rapidly three times when the backlight is dimmed.
54
Buzzer
-
1x beep
2x beep
5x beep
Continuous beeps
-
1x long beep (1 second)
LED
Constant
1x flash
2 x flash
5x flash
Continuously flashing
1x flash every 2 seconds
-