Programming Examples - Renkforce 1582597 Notice D'emploi

13. Programming examples

The following examples illustrate typical settings. These examples are not compulsory and are
provided for reference purposes only.
Record all configuration information and codes in a table or database. This helps
to obtain an accurate overview of all people with access rights and enables you to
disable access for specific individuals.
Example 1: Single-user mode
0 0 0 0
*
8 9 0 0 #
0 3 2 8 9 #
1 8 3 2 1 #
4 5 2 5 8 0
4 0 3 #
7 0 1 0 #
*
Example 2: Enable multi-user mode and set the keypad to lock for 15 minutes after an
incorrect code entry
Enter the master code to enable programming mode (the default
master code is "0000"). The yellow LED will stay constant.
Important - if you have programmed another master code, enter the
new code.
8900 # Enables single-user mode (enabled by default)
Important - If multi-user mode was previously enabled, all codes and
settings (except the master code) will be deleted!
Programs the master code to "3289"
Programs the user code to "8321"
Programs the superuser code for the relay to "2580"
#
The relay output will be enabled for 3 seconds when a user code is
entered
The code lock will be locked for 15 minutes after 10 incorrect code
entries
Exits programming mode, the yellow LED will flash slowly to indicate
that the code lock is in standby mode
77