Programming The Superuser Code; Deleting The Superuser Code - Renkforce 1582597 Notice D'emploi

*
m) Programming the superuser code
The superuser code is a multifunctional code that activates and controls a number of relay
functions. The superuser code is saved to memory slot 45 and can be 4–8 digits long. In auto-
entry mode, the superuser code must be the same length as the master code.
The superuser code and the door opener button are not affected by the code lock's
security measures (e.g. access block). For security reasons, you can activate the
relay at any time.
45 + [Superuser code] # = Program the superuser code
To program the superuser code, press the keys in the order shown in the left-hand diagram.
Follow the instructions on the right-hand side.
3 2 8 9
*
4 5
2 5 8 0
#
*
n) Deleting the superuser code
To delete the superuser code, proceed as follows:
3 2 8 9
*
4 5
#
*
68
Press the * key to exit programming mode. The yellow LED will start to
flash again. The code lock is now in manual entry mode.
Enter the master code (in this example, the master code is "3289", the
factory default setting) to enable programming mode, and then press the *
key. The yellow LED will stay constant to indicate that programming mode
is enabled.
Enter the memory code "45". Set the superuser code to "2580". Press the
# key to confirm your entry.
Press the * key to exit programming mode. The yellow LED will start to
flash again.
Enter the master code (in this example, the master code is "3289")
to enable programming mode, and then press the * key. The code lock
will beep twice and the yellow LED will stay constant to indicate that
programming mode is enabled.
Enter the memory code "45".
Press the # key to confirm your entry.
The super user code will be deleted.
Press the * key to exit programming mode. The yellow LED will start to
flash again.