Table des Matières
Publicité
q
w
r
e
w
e
5
4
3
q
Buttonhole
q Stitch pattern:
w Presser foot:
e Thread tension:
Carefully mark buttonhole length on fabric.
Place the fabric under the foot with the buttonhole
marking running toward you.
Move the slider toward you so that the top mark on
the slider meets the start mark. Line up the markings
on the foot with the starting point on the fabric.
q Slider
w Top mark on the slider
e Start mark
r Starting point
NOTE:
The scale on the slider is engraved in centimeters.
Set the pattern selector dial at "
Sew forward until you reach the front marking of your
buttonhole.
Stop sewing at a left stitch.
Set the pattern selector dial at "
Sew 5 stitches.
Stop sewing at a right stitch.
Set the pattern selector dial at "
Sew until you reach the back marking of the
buttonhole.
Stop sewing at a right stitch.
Set the pattern selector dial at "
Sew a few bartacks and raise the needle from the
fabric.
Remove the fabric from the machine and cut the
sewing thread. Pull the bobbin threads to bring the
needle threads to wrong side of the fabric and knot
the threads.
Insert a pin inside the bartack.
Then cut the opening with a seam ripper.
Take care not to cut the stitches.
30
4
4
(BH)
1
3
2
2
Buttonhole foot
1 to 5
".
1
4
".
2
3
".
4
".
2
Publicité
Table des Matières
