Télécharger Imprimer la page

Briggs & Stratton infohub 6517-00 Instructions D'installation page 3

Moniteur de surveillance sans fil

Publicité

Les langues disponibles

Les langues disponibles

SAVE THESE INSTRUCTIONS - This installation sheet
contains important safety instructions that should be followed
during installation of the equipment.
Safety Alert Symbol and Signal Words
The safety alert symbol
is used to identify safety
information about hazards that can result in personal injury.
A signal word (DANGER, WARNING, or CAUTION) is used
with the alert symbol to indicate the likelihood and potential
severity of injury. In addition, a hazard symbol may be used
to represent the type of hazard.
DANGER indicates a hazard which, if not avoided, will
result in death or serious injury.
WARNING indicates a hazard which, if not avoided, could
result in death or serious injury.
CAUTION indicates a hazard which, if not avoided, could
result in minor or moderate injury.
NOTICE indicates an action that could result in damage to the
product.
Hazard Symbols and Meanings
Electrical Shock
Rotating Parts
Only qualified, licensed electricians should perform this
installation, which must strictly comply with applicable
codes, standards, and regulations.
WARNING "This product can expose you to chemicals
including gasoline, engine exhaust, which is known to the
State of California to cause cancer and carbon monoxide,
which is known to the State of California to cause birth
defects or other reproductive harm. For more information
go to www.P65Warnings.ca.gov."
CAUTION Installing the 15 Amp fuse could cause
the engine to start at any time without warning,
resulting in minor or moderate injury.
• Observe that the 15 Amp fuse has been removed from the
control panel before servicing.
• DO NOT install this fuse until all wiring has been
completed and inspected.
WARNING Generator produces hazardous voltage.
• DO NOT touch bare wires or bare receptacles.
• DO NOT use generator with electrical cords which are
worn, frayed, bare, or otherwise damaged.
• DO NOT handle generator or electrical cords while
standing in water, while barefoot, or while hands or feet
are wet.
• If you must work around a unit while it is operating,
stand on an insulated dry surface to reduce the risk of a
shock hazard.
• DO NOT allow unqualified persons or children to operate
or service generator.
• In case of an accident caused by electrical shock,
immediately shut down the source of electrical power and
contact the local authorities. Avoid direct contact with the
victim.
• Despite the safe design of the generator, operating this
equipment imprudently, neglecting its maintenance, or
being careless could cause possible injury or death.
• Remain alert at all times while working on this equipment.
Never work on the equipment when you are physically or
mentally fatigued.
Auto Start
• Before performing any maintenance on the generator, first
disconnect the battery cable indicated by a NEGATIVE,
NEG, or (-). When finished, reconnect that cable last.
• After your system is installed, the generator may crank
and start without warning any time there is a power
failure. BEFORE working on the equipment, and to
prevent possible injury, always set the generator system
switch to OFF, remove the service disconnect fuse from
the disconnect box, and remove the 15 Amp fuse.
Failure to properly ground generator could result
in electrocution. Failure to isolate generator from
utility power could result in death or serious
injury to electric utility workers, due to back-
feed of electrical energy.
Safety
3

Publicité

loading