Description; Display And Connection Elements - JUMO dTRANS T1000 Notice

1 Introduction
1.2

Description

NOTE!
Please read this manual before starting up the device. Store this manual in a place that is accessible to
all users at all times.
The temperature sensor is used for temperature measurement and monitoring. The effect of the tem-
perature on a resistance RTD temperature probe generates a signal, which is amplified, digitalized and
processed.
The temperature sensor is equipped with an IO-Link interface as per specification 1.1. IO-Link supports
bidirectional communication and is used to exchange the process data, parameters, diagnostic informa-
tion and status messages. The two green LEDs are permanently lit as soon as power is supplied to the
device. Once an IO-Link connection is established, the LEDs flash.
The switching behavior and the switching thresholds of the switching outputs (max. 2 pcs.; p or n switch-
ing) can be individually configured, as can many other parameters. Any IO-Link master can be used for
the configuration.
The temperature sensor is thus suitable for use in plant and mechanical engineering in connections to
automation systems. Many process connections are available to the user.
1.3

Display and connection elements

(1) Protection tube with RTD temperature probe
(2) Status LED (other identical LEDs opposite)
(3) M12 connection
(4) Protective cap for storage and transport
4
(1) (2) (3) (4)