Mounting - JUMO dTRANS T1000 Notice

3

Mounting

The temperature sensor may only be installed, connected and started up by qualified and authorized per-
sonnel observing these operating instructions, the applicable standards, and the legal requirements (de-
pending on the application).
If you experience difficulties during installation and startup, please contact the manufacturer.
The device can be installed in any position.
NOTE!
The temperature sensor is not suitable for safety-critical applications.
NOTE!
The temperature sensor is not suitable for installation and application in potentially explosive areas.
NOTE!
The temperature sensor must be connected to the potential equalization system of the plant via the pro-
cess connection.
Mounting the sensor
• Insert the temperature sensor into the corresponding drilled hole and tighten it by hand, making sure
the profile seal and/or O-ring (if fitted) are sitting correctly
• Tighten the temperature sensor with a suitable wrench
 For the wrench size, see chapter 1.4 "Dimensions", page 5
3 Mounting
13