Brinly FDK-10BH Manuel Du Propriétaire page 10

================================================================================================
STEP 5-C
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
Aligning the Pivot Arms
Temporarily slide the rocker
base (1) into the slots of the
pivot arms (2) and (3).
See Illustration.
Tighten the four 5/16" nuts
(18) from Steps 5-A and 5-B
(reference pages 8-9).
Remove the rocker base (1) from the
assembly (this will be used on step 6,
page 11).
STEP 5-D
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
Find this hardware:
- x2 Bolt; Carriage (18) - 5/16" x 1"
- x2 Washer; Lock (15) - 5/16"
- x2 Nut; Hex Head (13) - 5/16"
Align the A-frame support bracket (6) from
above the axle and run each bolt through.
Add a lock washer (15) to both bolts (18)
and secure fully under the A-frame with two
Nuts (13).
English Manual
ASSEMBLY
2
3
x4
15
13
10
1
18
6
15
1018671-A