Starting Your Automatic Door; Starting Your Automatic Door (Case Of Emergency Exits With Tüv Specifications) - Portalp DIVA Notice Utilisateur

3

* Starting your Automatic Door

Since the door is plugged on the mains (power supply),
a / Your door closes slowly until the leaves are completely closed (memorization
of the closed position).
b / The first time the door receives a command to open, it opens slowly
(memorization of the opening position).
After the mains had been missing for more than 3 minutes, the two cycles (a
and b) will be automatically done when the mains will be restored.
This is not valid if the door was locked before.
Starting your Automatic Door
(Case of emergency Exits with TÜV specifications)
If the mains is present :
Lock the door by using the external key contactor. Hold it until the complete
closed position of the sliding leaves.
Then you have two possibilities.
1 / If the mains comes back after it had been missing for more than 3 minutes :
after unlocking with the key contactor, when a first opening is asked, the door
opens slowly until the end opened position.
After it came back in closed position, the door checks the pre-tensioned rubber
cord.
2 / If the mains comes back after it had been missing for less than 3 minutes:
after unlocking, the door checks the pre-tensioned rubber cord.
If the mains is missing :
Give an impulse on the "reset position" with the key contactor.
Then, lock the door by using this key contactor.
70