2. By using the key *
Locking
Whatever the mode and opening displayed on the
control panel, insert the key, turn it a quarter turn
and return to the original position.
Your door closes immediately.
A long tone confirms that your electrical locking has
functioned correctly.
Your control panel then displays :
Selection window : "LK" : Locked with Key
Adjustment window : "-b" : mechanical
blocking activated ; at the same time, the red
indicator on the cylinder lights up.
Unlocking :
Insert the key, turn it a quarter turn and return to the
original position.
A short tone is emitted, the light goes out and the
( 1 )
door opens
.
The control panel again displays the mode and
opening selected before locking.
Withdraw the key.
(1)
The door opens and closes again after an interval defined at the time of installation
(approximately ten seconds). If the mode selected is Closed * or Exit, you cannot enter again
after closing. In this case, repeat the complete locking and unlocking cycle.
In the event of a power failure :
In the event of a power failure, lock or unlock the door with the key in the same
way. The movement will be slower, as your operator will be supplied by the
battery, and the red light indicating correct locking will go out after a few
seconds.
1
55