Portalp DIVA Notice Utilisateur page 54

Addressing of one door selectively
A single remote control can be used to command several DIVA automatic
doors.
When they are located in the same place, close to each other and directly in line
with your remote control, they will receive together the orders and settings you
make.
A number was allocated to each door during the installation.
To command one single door out of those located within the reception range of
you remote control, proceed as follows :
1 / Press simultaneously the CODE key and the numbercorresponding to the
door to be commanded ; Do this while moving the remote control over the
doors you don't wish to command.
As soon as they received this instruction, they will display a message
in their " selection " and " settings " windows , stating that they will not carry
out any orders emitted by the remote control for the next 15 seconds.
2 / Command the door selected
3 / If you don't wish to wait 15 seconds before commanding another door, press
simultaneously CODE and RESET keys while pointing the remote control at
the doors ; The selection and adjustment windows will once more display
their original messages.
1
49