Safety Instructions Related To The Product And Technology - Aventics PROFINET-IO Mode D'emploi

68 AVENTICS | PROFINET-IO | R412015162–BDL–001–AE
Notes on Safety
During assembly
W
You may only commission the product if you have
determined that the end product (such as a machine or
system) in which the AVENTICS products are installed
meets the country-specific provisions, safety regulations,
and standards for the specific application.
2.6 Safety instructions related to the product
and technology
W
Do not place any mechanical loads on the device under any
circumstances. Do not place any loose objects on it.
W
Ensure that the power supply is within the stipulated
tolerance for the modules.
W
Observe the safety notes in the operating instructions for
your valve system.
W
A 24 V power pack supplies all components with electricity.
The power pack must be fitted with a safe isolation in
accordance with EN 60742, VDE 0551 classification. The
corresponding electrical circuits are thus SELV/PELV
circuits in accordance with IEC 60364-4-41.
W
Switch off the operating voltage before connecting or
removing the plugs.
W
The warranty only applies to the delivered configuration.
The warranty will not apply if the product is incorrectly
assembled.
W
Always make sure the relevant system component is not
under pressure or voltage before assembly or disassembly.
Ensure that the system is prevented from power restoration
during assembly work.
W
Ground the modules and valve system. Observe the
following standards when installing the system:
– DIN EN 50178, VDE 0160 classification
– VDE 0100