Important Points To Note Before Use; Filling The Water Tank; Use As A Fl Oor Steam Cleaner - Cleanmaxx SM102B Mode D'emploi

❐ When cleaning, ensure that the fl oor cleaning cloth is fi rmly attached to the cleaning head
in order to avoid damage to the appliance or fl oor covering.
❐ Never direct the steam at people, animals or equipment which contains electrical compo-
nents (e.g. oven interiors, refrigerators, switches and lights, microwaves etc.).
❐ Beware - risk of scalding! Never touch the appliance's cleaning head/attachment while
in use.
❐ The fl oor cleaning cloth can remain very hot for a short time after use. If you want to
remove it, wait until it has cooled down and the appliance is no longer emitting any steam.
❐ Put the appliance back in its place only when it has completely cooled down.

Important points to note before use

• Water residue in the fi lter and in the tank can be attributed to the appliance having been
tested.
• When using the appliance for the fi rst time, or if the appliance has not been used for a
long time, it may take some time after switching on for steam to be generated, as the ap-
pliance's pipes are not yet fi lled with water. Steam can only be emitted when the appliance
has reached its operating temperature and the appropriate parts of the appliance have
fi lled with water. To do this, press the steam activator several times.

Filling the water tank

Use as a fl oor steam cleaner
It is recommended that the fl oor is swept with a brush or vacuum cleaned before using the
appliance.
1. If the base unit (2) is already in the stand for fl oor cleaning, miss out the following steps 1 to 3.
If the adapter (25) (with an attachment) is fi tted to the base unit, press on the adapter's
unlatching lever and remove it from the base unit.
02626_DE-GB-FR-NL_V0.indb 22 02626_DE-GB-FR-NL_V0.indb 22
1. Press both the unlatching buttons on the water tank (4) at
the same time and remove the water tank from the base unit.
2. Turn the water tank catch (3) anticlockwise slightly and re-
move it from the tank.
3. Fill the tank with water. If you want to use a fragrance additive,
follow the instructions that come with it.
4. Then lock the water tank by replacing the water tank catch
and turning it clockwise.
5. Place the water tank back into the base unit. Press it down
until it is fi rmly in place.
22
26.10.12 07:30 26.10.12 07:30