Burkert 3003 Manuel D'utilisation page 16

7.4.1. specify position of the plug-in
jumpers
OFF ON
Fig. 7: Plug-in Fig. 8:
jumper K1
/ K2
signal feed- plug-in jumper
trans- back K1
ducer
a
0-10 V 0-10 V ON
0-10 V 0-20 mA ON
0-10 V 4-20 mA ON
0-20 mA 0-10 V OFF
0-20 mA 0-20 mA OFF
0-20 mA 4-20 mA OFF
4-20 mA 0-10 V OFF
4-20 mA 0-20 mA OFF
4-20 mA 4-20 mA OFF
16
Plug-in Fig. 9: Plug-in
jumper jumper
K3 OFF K3 ON
plug-in jumper plug-in
K2 jumper
B a B
OFF ON OFF OFF
OFF OFF ON OFF
OFF OFF ON
ON ON OFF OFF
ON OFF ON OFF
ON OFF ON
ON ON OFF OFF
ON OFF ON OFF
ON OFF ON
english
7.4.2. parameterization steps
specify direction of rotation of the shut-off valve
normal direction of rotation (preset)
G
reverse direction of rotation
K3
R
ON
specify control signal type
control signal when voltage 0 – 10 V
ON
R
ON
Type 3003
Installation
→
Press <OPEN> pushbutton and switch on
the card (hold down pushbutton).
The GREEN LED lights up.
→
Release <OPEN> pushbutton and disconnect
the card from the power supply.
→
Press <CLOSE> pushbutton and switch on
the card (hold down pushbutton).
The RED LED lights up.
→
Release <CLOSE> pushbutton and disconnect
the card from the power supply.
→
Press <MEM> pushbutton and switch on the
card (hold down pushbutton).
The RED LED lights up 3x.
→
Release <MEM> pushbutton and disconnect
the card from the power supply.