Circuit Board For Actuator With Standard Signal Input - Burkert 3003 Manuel D'utilisation

7.4. circuit board for actuator with
standard signal input
N
L
G
H
B
C
A
M
Fig. 6: Circuit board
A Electrical power supply
24 V AC/DC
B Connection terminals of
the input signal
C Connection terminals of
the feedback
Type 3003
Installation
D
E
F
J
K
I
H K2 plug-in jumper
I K3 plug-in jumper
J Green and red LED
D MEM pushbutton
E CLOSE pushbutton
F OPEN pushbutton
G K1 plug-in jumper
To prevent electromagnetic interference, shielded cables
must be used.
procedure:
→
Loosen the cable gland and feed the cable through.
→
Wire the signal transducer between terminals 15 and 16. Terminal
15 is the negative pole (-) and terminal 16 the positive pole (+).
→
Wire the position feedback sensor between terminals 13 and 14.
Terminal 13 is the positive pole (+) and terminal 14 the negative
pole (-).
→
Re-attach the cable gland.
If the connection voltage is 100 V to 240 V, a fuse must be
provided in the power supply.
english
K LED yellow: Indicates the
power supply
L Potentiometer
M Motor connection
N Heat resistor connection
15