Titan TP 600 Mode D'emploi page 34

9.3 Replacement of the gripper plates on the bottom plate
Remove the 6 fastening screws (Pos. 87) from the bottom plate (Pos. 77) (figure 9.3.1).
Afterwards remove the 5 screws (Pos. 86) (figure 9.3.2) and replace the required
gripper plates (Pos. 78 - 80) (figure 9.3.3).
Figure 9.3.1
Reassemble it in reverse order.
9.4 Replace gripper plate, welding
To replace the gripper plate of the welding unit it‟s necessary to remove the cutter and
the bottom plate first, as described under point 9.1 + 9.3. Then remove the circlip
(Pos. 26) from the retaining bolt gripper plate (Pos.25) (figure 9.4.1) and pull the
retaining bolt gripper (Pos. 25) out of the gripper plate welding (figure 9.4.2) and
replace it (figure 9.4.3).
Figure 9.4.1
Reassemble it in reverse order.
9.5 Cleaning work area
Remove the plastic
strap residues from
the feed wheel,
gripper plates and
the cutter, e.g. by
means of
compressed air, at
regular intervals,
depending on use.
TP 600
Figure 9.3.2
Figure 9.4.2
H TP 600 EU 37/11
Figure 9.3.3
Figure 9.4.3
34