Hf Surgical Devices Me Mb3 / Me 411 - KLS Martin group 80-070-00-04 Mode D'emploi

EN
3.3

HF Surgical Devices ME MB3 / ME 411

If you wish to install a KLS Martin ME MB3 or ME 411 unit on the Cart, you need the optional
KLS Martin mounting system (item no. 08-022-00-18) – see illustration below. The system
consists of items (5) and (6).
The HF Cart comes with matching threads (2) already provided in the inclined base plate (see
illustration in section 3.2, " HF Surgical Device maXium
Figure 2: Optional installation of HF devices requiring the KLS Martin mounting system
3 Retaining pins
4 HF device ME MB3 or ME 411
5 4 M4x12 cheese head screws with 4 washers
6 1 fixing bracket
7 Inclined base plate
To fix the HF device in place, proceed as follows:
Remove the retaining plate from the inclined base plate of the HF Cart.
•
(See item (1), "Retaining plate", in section 3.2, "HF Surgical Device maXium
• Using pincers, screw two retaining pins (3) into the holes provided in the base plate (7).
Fit the bracket (6) to the rear wall of the HF unit (4) using the screws (5).
•
Put the HF unit in place, engaging its front part with the retaining pins (3).
•
• Screw the bracket (6) in place in the threaded hole of the base plate.
(See "Threaded holes" (2) in section 3.2, "HF Surgical Device maXium
This prevents the HF unit from slipping or falling off.
22
HF Cart Item No. 80-070-00-04
®
", page 21).
®
", page 21).
Instructions for Use
®
", page 21.)
Revision 1