Removing/Installing And Adjusting The Cutter Deck - Cub Cadet H21 Notice D'instructions Originale

EN
Note
If the donor battery is installed in a vehicle,
this vehicle must not be started during the
jump starting process.
Start the lawn tractor.
Î
Switch the parking brake on.
Î
Disconnect the jump leads in reverse sequence.
Î
Tyre pressure
Increased tyre pressure
ÂRisk of accident and damage to the device
¾ Never exceed the permitted tyre
pressure (see tyre wall).
Check the tyre pressure and correct it where necessary.
Î
front: 0.9 bar
rear: 0.7 bar
Note
Excessive tyre pressure reduces the service
life of the tyres. Check tyre pressure prior to
each journey.
After 5 operating hours
Perform the first engine oil change (for intervals
Î
refer to the engine manual).
Use the quick oil drain (optional) to drain the oil V .
Î
Note
When draining the oil, use a suitable collec-
tion container.
Every 25 operating hours
Lubricate all pivot points and bearing points of the
Î
accelerator and brake pedals, of the cutting height
adjustment lever and of the PTO lever with a few
drops of light oil.
Clean the battery terminals.
Î
Lubricate all blade shafts, tensioning pulleys and
Î
tensioning pulley holders via the grease nipples
using grease type 251H EP.
Note
Arrange for this work to be carried out by a
service centre.
Lubricate the wheel bearings and front wheel
Î
axles at the lubricating nozzles using a multi-pur-
pose grease.
Lubricate the wheels of the cutter deck at the
Î
lubricating nozzles with a multi-purpose grease.
Have the dirt and grass residue beneath the V-belt
Î
cover of the cutter deck removed by a service
centre.
22
WARNING!

Removing/installing and adjusting the cutter deck

Every 50 operating hours
Dirt and grass remnants must be removed from
Î
the drive gear by a service centre.
Have drive V-belts, blade shafts and tensioning
Î
pulleys checked for wear and damage by a ser-
vice centre.
If required
Charge the battery:
If you are not using the battery for lengthy periods,
Î
remove the battery from the device.
Charge up the battery every 6–8 weeks, as well
Î
as before putting back into operation after storage.
Note
Follow the instructions in the operating man-
ual for your battery charger.
Replace fuses:
Replace defective fuses only with ones of an
Î
equal rating.
Note
The fuse is located on the red cable below
the driver's seat.
Once a season
Clean the spark plugs and set the electrode gap
Î
or replace the spark plug (see engine manual).
The rear axles must be lubricated with a special-pur-
Î
pose, water-repellent grease by a service centre.
Have the cutter deck repaired only by a service centre.
Î
Removing/installing and adjusting the cut-
ter deck
Risk of injuries or material damage
¾ Only perform maintenance and cleaning
work on the device with the engine at a
standstill.
¾ Remove the ignition key and the spark-
plug connectors.
¾ Wait until all moving parts have come
to a complete stop and the engine has
cooled down.
¾ Never reach into the rotating cutter blades.
¾ Wear protective gloves.
¾ Only have repair and maintenance
work and the replacement of safety
components performed by a qualified
specialist or a specialist service centre.
¾ Note that the movement of one cutting
tool may lead to the rotation of other
cutting tools.
WARNING!