Cub Cadet H21 Notice D'instructions Originale page 18

EN
OCR function (model-dependent) H
The ignition lock is fitted with an OCR function,
which offers you user-controlled mowing, even when
reversing.
Information on mowing
Only use the OCR function if absolutely
necessary.
Start the engine.
Î
Turn the ignition key [3] anti-clockwise from
Î
normal position to reverse-mowing position
and press switch [1] a .
or
Press switch [1] b for 3 seconds.
3 The indicator lamp [2] lights up. You can now mow
both when moving forwards and when reversing.
To terminate the OCR function, turn the ignition
Î
key clockwise to the normal position
or
Press the switch [1] b downwards and then
release it.
3 The indicator lamp goes out.
Information about the ignition lock Ha
The OCR function is switched off automat-
ically once the key is turned to the normal
position or the engine is switched off (stop
position or switching off of the engine via the
safety locking system).
Information about the ignition lock Hb
The OCR function is switched off auto-
matically once the OCR switch is pressed,
the engine is shut down or the safety lock
system automatically switches the engine or
the cutting mechanism off.
Mulching
With mulching, the grass is cut into small pieces
(approx. 1 cm) during mowing and is left on the
ground. A lot of the nutrients in the cut grass are
retained for the benefit of the lawn.
Ask your specialist dealer for appropriate mulching
Î
accessories.
Tips on lawn care
A lawn comprises various grass types. If you mow
more frequently, the grown of strongly-rooting
grasses is favoured resulting in firm turf.
If you mow only rarely, the growth of tall grasses and
other weeds (e.g. clover, daisies) is encouraged.
To ensure you lawn grows healthily and uniformly,
without any lines, the cutting stripes must always
overlap by a couple of inches/several centimetres.
18
- The normal height of the lawn is 40–50 mm. Cut
approximately one third of the overall height as
soon as the lawn has reached a height of 60-
70 mm.
- Do not cut the lawn shorter than 45 mm as other-
wise the turf can be damaged during dry periods.
- Cut long grass in stages until normal height is
reached.
Switching on the headlights
(model-dependent) R
To turn the headlights on, set the switch to "ON".
Î
3 The headlights are switched on while the engine
is running.
Note
The headlights switch on and off automat-
ically with the engine on models without a
light switch.
. Note
Dependent on the model, the headlights stay
lit up for approx. 10 seconds after the engine
has shut down and then switch themselves
off automatically.
Switching the differential lock on and off
(model-dependent) A
An activated differential lock has a strong
influence on the steering performance of
the device.
ÂRisk of injury and damage to the device
¾ Only use the differential lock when
absolutely necessary; e.g. on difficult
terrain.
¾ Only activate the differential lock when
the device is at a standstill.
¾ Do not use the differential lock on paved
pathways or downhill.
¾ Only drive straight ahead when the
differential lock is on.
¾ Only drive slowly with the differential lock
on.
With the differential lock on, power is transmitted to
both rear wheels. The differential lock intervenes if
different wheel speeds are detected.
Stop the device.
Î
To turn on differential lock, step on the pedal L.
Î
To turn off differential lock, remove your foot from
Î
the pedal again L.
WARNING!
Operation