Display Cluster (Depending On The Model; Optional) - Cub Cadet H21 Notice D'instructions Originale

Display cluster (depending on the model; optional)

Note
If the differential lock does not release im-
mediately, reduce the speed of the device or
bring the device to a standstill.
Switching the device off
Stop the device.
Î
Switch the cutter deck off.
Î
Set the throttle to the middle position.
Î
Bring the cutter deck to the top position.
Î
Switch the engine off after 20 seconds.
Î
Switch the parking brake on.
Î
Remove the ignition key.
Î
Pushing the device K
Switch the engine off.
Î
Switch the parking brake off.
Î
Pull the gear release lever out fully.
Î
3 You can now push the tractor.
Note
Before you start the engine, press the gear
release lever back in fully.
12 volt socket (model-dependent) A K
The socket is used for connection of a 12 volt
battery charger or connection of miscellaneous
12 volt devices.
Note
Observe the corresponding information of
the battery charger or the 12 volt devices
that are to be connected.
Display cluster (depending on the model;
optional)
Note
The indicators only come on when the en-
gine is running.
Note
If the oil change and air filter maintenance
occur at the same time, the oil change
indicator appears first and then the air filter
indicator.
Depending on the design, the display cluster can
consist of the following elements G:
Type 1 Oa in conjunction with the ignition
lock Ha
Operating hour counter
When the ignition is switched on, the battery voltage
indicator is displayed for a short period, which then
changes to the operating hours indicator.
The operating hours are always counted except
for when the ignition key is in the "Stop" position or
when it is removed.
Maintenance indicator
Note
means: The total operating hours are
displayed.
– – –
Change the engine oil immediately (see engine
Î
operating manual).
This indicator appears every 50 operating hours for
a period of 2 hours.
– –
The engine oil level is too low.
If the indicator does not go out, switch the engine
Î
off immediately and check the engine oil level (see
the engine operating instructions). Top up the oil if
required.
This indicator may appear briefly after the engine has
started and then go out again.
Note
This function is only active for engines with
an oil pressure switch.
– –
If you turn the ignition key to the
battery voltage is briefly shown and then the total
operating hours.
Charge the battery as quickly as possible.
Î
It may be necessary to have the charging system
Î
checked by a service centre for possible damage.
– –
Perform air filter maintenance immediately (see
Î
engine operating manual).
This indicator appears every 25 operating hours for
a period of 7 minutes.
Changing the oil
Oil level
Battery voltage
position, the
Air filter mainte-
–
EN
nance
19