Franklin Electric SubDrive Connect Plus Guide De Démarrage Rapide page 18

Safety Information
Risk of damage to drive or other equipment.
• Install and wire VFD according to the instructions in this manual.
• Take protective measures against ESD (Electrostatic Discharge) before
touching control boards during inspection, installation or repair.
• Do not connect power factor correction capacitors, surge suppressors,
or RFI filter to the VFD output.
• Check if input power voltage is within acceptable range before applying
power to VFD.
• Set correct motor data from the motor nameplate and overload protec-
tion parameters for proper motor overload protection.
• Do not modify VFD internal components and circuits.
• The use of any disconnecting device (contactor, disconnect etc.) in
motor circuit during VFD run can cause damage to VFD power compo-
nents. Stop VFD before opening the motor circuit with disconnect or
contactor.
• This product is recommended for use with Franklin Electric 4-inch and
6-inch submersible motors or above-ground centrifugal motors. Use of
this unit with any other Franklin Electric motor or with motors from
other manufacturers may result in damage to both motor and electron-
ics.
• In applications where water delivery is critical, a replacement pressure
sensor and/or back-up system should be readily available if the drive
fails to operate as intended.
For technical assistance, parts, or repair, please contact:
800.348.2420 | franklinwater.com
Form 226203202 Rev. 001 11/21
Copyright © 2021 Franklin Electric, Co., Inc. All rights reserved.