Osmosis System Or Other Household; Step 3 Install Side Panels; Step 4 Anti-Tip Procedure - Monogram ZIC360NNRH Instructions D'installation

Installation Instructions - Stainless Steel Installation
STEP 2A WATER LINE
INSTALLATION WITH A REVERSE
OSMOSIS SYSTEM OR OTHER
HOUSEHOLD FILTRATION SYSTEM
Skip this step when not using an RO System or
other household filtration system
If the water supply to the refrigerator is from a
household filtration system, use the refrigerator's filter
bypass plug. Using the refrigerator's water filtration
cartridge with the RO filter can result in hollow ice
cubes.
Filter Bypass Plug

STEP 3 INSTALL SIDE PANELS

Skip this step when not using side panels.
If you are using 1/4" (0.63 cm) side panels, they should
be inserted into the case trim. Fasten the panels to the
refrigerator with stick-on hook and loop fastener strips
before setting refrigerator in place.
31-1000452 Rev. 1

STEP 4 ANTI-TIP PROCEDURE

WARNING
These refrigerators are top heavy, especially with any
doors open, and must be secured to prevent tipping
forward which could result in death or serious injury.
Read and follow the entire installation instructions for
securing the refrigerator with the anti-tip system.
AVERTISSEMENT
basculement Ces réfrigérateurs présentent une
partie supérieure lourde, en particulier avec une
porte ouverte; ils doivent donc être fixés pour
prévenir le basculement vers l'avant et le risque
concomitant de blessure grave ou fatale. Lisez et
suivez les instructions d'installation complètes pour
l'installation du système anti-basculement.
ADVERTENCIA
Estos refrigeradores son inestables, especialmente
cuando una puerta se encuentre abierta, y deberán estar
asegurados a fin de evitar caídas hacia adelante que
podrían resultar en la muerte o en lesiones graves. Lea y
siga las instrucciones de instalación en su totalidad para
asegurar el refrigerador con el sistema anti volcaduras.
• The kit supplied with the unit contains 2 lag bolts and
4 toggles with bolts. The wall bracket will be attached
to the wall in 4 places.
• Measure the opening where the unit is to be installed.
Mark the center with a vertical line.
• Measure up 81 1/2" (207.01 cm) from the floor. Mark
this point
on the wall.
• Using
a level,
draw a
horizontal
line on the
wall at this
height.
• Locate
at least 2
studs on
the back
wall. Mark
these
points
on the
horizontal
line.
31
Tip Over Hazard.
Risque de
Riesgo de Caídas