Reely « Mini Bulldog » 4WD RtR Notice D'emploi page 43

• When the vehicle battery is nearly empty, the vehicle will slow down and may not respond properly to
the remote control.
The vehicle battery powers the engine (via the built-in speed controller) as well as the receiver, the steer-
ing servo and the two-gear servo.
For this purpose, the speed controller features an integrated BEC ("Battery eliminator circuit", an elec-
tronic circuit that supplies a voltage directly to the receiver without an additional receiver battery).
If the voltage in the vehicle battery is too low, this affects the receiver and may cause the vehicle to stop
responding to remote control commands.
If this occurs, stop driving the vehicle immediately (switch off the vehicle, disconnect the vehicle battery
and switch off the remote control). Replace or recharge the vehicle battery as necessary.
Allow the battery to cool down completely before recharging it.
• The engine, drive, electronic components and vehicle battery heat up during use. Pause for at least 5–10
minutes before changing the battery.
• Do not touch the engine, speed controller/receiver or the battery until they are completely cool. Burn
hazard!
43