Preparations For Security Lock; Mounting - Fronius Acctiva Smart 25 A Instructions De Service

Wall bracket op- Different wall plugs and screws will be required depending on the supporting sur-
tion face. Wall plugs and screws are therefore not included in the scope of supply.
The installer is responsible for selecting the right wall plugs and screws.
Preparations for
security lock

Mounting

NOTE!
Danger due to improper installation of the charger in a switch cabinet (or in a si-
milar enclosed space).
This can result in damage to property.
▶
▶
The space requirement dimensions in mm (inches) illustrated below are given to
ensure that there is easy access to the plug connections:
"click"
Ensure sufficient heat dissipation using forced-air ventilation.
There should be a clearance of 10 cm (3.94 in.) all around the device.
"click"
The security lock is not contained in
the scope of supply.
A security lock can only be attached
- to the groove on the housing as
shown.
- to the groove on the housing that
is exactly opposite.
-
using spacer M8 DIN 125 or DIN
134, located as shown.
61