Power Supply Mode; Requirements - Fronius Acctiva Smart 25 A Instructions De Service

Power supply mode

Requirements

In Power supply mode, the charger leads are connected directly to the battery
leads or the vehicle jump start points. It ensures that the vehicle electronics are
supplied with power while the battery is removed during repair work. As only the
vehicle battery leads are connected to the charger, the battery voltage recogniti-
on function is not available.
Power Supply
NOTE!
mode
Danger of an incorrect vehicle-specific voltage setting.
This can result in severe damage to the vehicle electronics.
▶
1
4
-
76
Before connecting the charger to the vehicle battery leads, ensure that the
correct voltage has been set.
Plug in charger mains plug
Select Power Supply mode using the up/down keys
2
Use the Menu key to select the vehicle power supply
3
voltage (6 V / 12 V / 24 V).
Connect the charging leads to the vehicle battery leads as described below -
the de-energised charging leads mean there are no sparks when connecting
the battery, even if the charger is already connected to the mains supply.
- Connect the red charging lead to the positive (+) vehicle battery lead
- Connect the black charging lead to the negative (-) vehicle battery lead
A safety message appears on the display asking whether the charging leads
are connected correctly.
Use the Stop/Start key to confirm the safety message
5
and start supplying the vehicle electronics with power.