Battery Changing Mode; General Information; Changing The Battery - Fronius Acctiva Smart 25 A Instructions De Service

Battery changing mode

General informa- Battery changing mode supplies the vehicle electronics with power while the bat-
tion tery is replaced. Before disconnecting the old battery from the vehicle electro-
nics, the charger leads must be connected to the vehicle battery leads. This con-
nection must remain in place until the new battery is connected.
Changing the
NOTE!
battery
Danger of incorrect voltage setting.
This can result in severe damage to the vehicle electronics.
▶
1
3
NOTE!
Danger if the wrong battery voltage is set.
This can result in damage to property.
▶
74
Always set the correct voltage after connecting the charger to the vehicle
battery leads.
Plug in charger mains plug
Select Battery changing mode using the up/down keys.
2
Connect the charging leads to the vehicle battery leads as described below -
the de-energised charging leads mean there are no sparks when connecting
the battery, even if the charger is already connected to the mains supply.
- Connect the red charging lead to the positive (+) vehicle battery lead
- Connect the black charging lead to the negative (-) vehicle battery lead
Always ensure that the correct battery voltage is set.
The charger automatically identifies
the battery, e.g. 12 V, and starts powe-
ring the vehicle electronics after 5 se-
conds.
If the battery voltage is not correctly
identified (e.g. usually the case if a bat-
tery is deeply discharged), you have 5
seconds to enter the correct battery
voltage as follows: