Assembling The Stator; Sending The Pump To The Manufacturer - LUTZ B70H Manuel D'utilisation

en

8.3 Assembling the stator

!
WARNING
If the locking clip is loose or incorrectly mounted, the stator sleeve is not secured against twisting.
This can result in:
- inadmissible heating. There is an explosion risk in explosion hazard areas!
- increased wear.
- twisting the hose line.
- Damages on the container.
For safe use of the pump, the stator sleeve must be mounted correctly:
► Insert the stator sleeve over the rotor (→ Fig. 17, item 1).
► Position the clamp sockets in such a way that the notches of both sockets are aligned to each other
(→ Fig. 17, item 2).
► Use the supplied locking clip with the welded pin (→ Fig. 17, item 3).
► Connect the sockets using the locking clip and position the pin so that it sits in the notches of the
socket (→ Fig. 17, item 4).
► Tighten locking clip with manual force.
Fig. 17

8.4 Sending the pump to the manufacturer

3 Pump pressure-less
3 Pump completely emptied
3 Electrical connections separated; motor secured against reactivation
3 Pump cooled down
► Only return the pump to the manufacturer with an accurately completed document of compliance.
21