Nespresso Latissima Pro Mode D'emploi page 18

TROUBLESHOOTING
EN
FR
No light on display.
Machine too hot message, indicated in display.
Coffee comes out very slowly.
Coffee is not hot enough.
Capsule area is leaking (water in capsule container).
Irregular blinking.
No coffee, just water runs out (despite inserted capsule).
Lever cannot be closed completely.
Quality of milk froth is not up to standard.
Machine needs repair message, indicated in display.
18
6926_UM_LATTISSIMA_PREMIUM_Z2A_LEG.indb 18
➔ Check the mains, plug, voltage, and fuse. Press the ON button located behind the machine
display. In case of problems, call the Nespresso Club.
➔ In certain conditions, machine heater reaches high temperature, (ie. after an emptying of
the fluid system). Simply wait, machine will cool down automatically.
➔ Flow speed depends on the coffee variety.
➔ Descale if necessary; see Descaling section.
➔ Preheat cup.
➔ Descale if necessary; see Descaling section.
➔ Position capsule correctly. If leakages occur, call the Nespresso Club.
➔ Send appliance to repair or call the Nespresso Club.
➔ In case of problems, call the Nespresso Club.
➔ Empty capsule container. Make sure that no capsule is blocked inside the capsule
container.
➔ For a perfect milk froth, use skimmed or semi-skimmed milk at refrigerator temperature
(about 4° C).
➔ Rinse after each milk based preparation. Place a recipient under milk outlet, rotate the
milk regulator knob until «CLEAN» position.
➔ Every two days, disassemble the R. C. S. and clean all components in the upper level of a
dishwasher.
➔ Contact the Nespresso Club or Nespresso authorized representative for examination,
repair or adjustment.
02.05.14 15:04