Data Storage Program - HPI Racing reactor 500 Manuel D'installation

For your convenience the Reactor 500 has the ability to store and load your program data. It can
store up to 5 sets of battery data. You can recall this data when charging or discharging without the
need to set up the program again.
PROGRAM SELECT
SAVE DATA
BATT START
Data STOP ENTER Type of
Number Battery
SAVE [01] NiMH
14.4V 3000mAh
Voltage
Capacity
BATT START
>3 Seconds
STOP ENTER
*
NiMH CHARGE Aut
CUR LIMIT 5.0A
DEC INC
DEC INC
*
NiMH DISCHARGE
1.0A 11.0v
DEC INC
DEC
INC
DEC INC
Pressing START/ENTER will then allow you to cycle through your saved
data. "INC" or "DEC" will select the next saved battery. Pressing the
START/ENTER key will select that data. The example is a NiMH battery
which has 12 cells and a capacity of 3000mAh.
Once selected the charge current can be altered, or the current limit in
"AUTO" mode. Press "INC and "DEC" simultaneously to make the current
field blink to switch the charge mode.
In "DISCHARGE" mode you can set up the discharge current and final
voltage
27

Data Storage Program