Charging A Lithium Battery In Charge Mode - HPI Racing reactor 500 Manuel D'installation

LiPo CHARGE
2.0A 11.1V(3S)
DEC DEC
INC INC
BATT START
>3 Seconds
STOP ENTER
R: 3SER S: 3SER
CONFIRM (ENTER)
START
Number Battery
ENTER
of cells Voltage
LP3S 1.2A 12.59V
CHG 22:43 00682
Charging Charging Charged
Current Time Capacity
The "CHARGE" charging mode is for charging LiPo/Li-ion/LiFe battery without the balancing lead.
The value on the left on the second line is the current. After setting the
current and voltage, press START/ENTER key for 3 seconds or more to
start the process. (Current: 0.1-5.0A Voltage: 3.7-22.2v)
This display shows the number of cells detected by the charger and the
number set manually by the user. "R" is the chargers reading. "S" is the
user set value, set previously. If both numbers are the same you can
start charging by pressing the START/ENTER Key. If not press
BATT.TYPE/STOP key to go back and amend if needed.
This screen shows the real time status during the charge process. Press
BATT.TYPE/STOP key once to stop the charge process.

Charging a Lithium battery in charge mode

17
Charging a Lithium battery