Discharging A Lithium Battery - HPI Racing reactor 500 Manuel D'installation

LiPo DISCGARGE
1.0A 11.1V(3S)
DEC DEC
INC INC
BATT START
>3 Seconds
STOP ENTER
Number Battery
of cells Voltage
LP3S 0.4A 12.59V
DSC 22:43 00682
Elaspsed
Discharge Discharged
Current Time Capacity
BATTERY VOL ERR
CELL LOW VOL
INC
4.14 4.16 4.09
2.18 0.00 0.00
Voltage balancing and monitoring during the discharge process
The processor monitors the voltage of each cell during the "STORAGE" and "DISCHARGING"
process. If the voltage of any cell is abnormal, the Reactor 500 will show an error message and
stop the current process. By pressing the "INC" key a report can be seen which will let you know
which cells are reading abnormally.
The value of the discharge current on the left of the screen can not
exceed 1C, and the value on the right can not be under the voltage
recommended by the manufacturer to avoid deep discharging. Press
START/ENTER for more than 3 seconds to start discharging.
This screen shows the real time status of the discharging, you can press
BATT.TYPE/STOP key to stop discharging at any time.
If this screen shows, the processor has detected that the voltage of one
cell is too low.
This screen can show the listed voltage of each cell. In this case the
4th cell is damaged. The voltage levels can be seen if the charger auto
detects a problem.
21

Discharging a Lithium battery