Charging A Lithium Battery In Balance Mode - HPI Racing reactor 500 Manuel D'installation

Balance charging a Lithium battery
LiPo BALANCE CHG
2.0A 11.1V(3S)
DEC DEC
INC INC
BATT START
>3 Seconds
STOP ENTER
R: 3SER S: 3SER
CONFIRM (ENTER)
START
Number Battery
ENTER
of cells Voltage
LP3S 1.2A 12.59V
BAL 22:43 00682
Charging Charging Charged
Current Time Capacity

Charging a Lithium battery in balance mode

The "BALANCE" function is for balancing the voltage of Lithium-Polymer battery cells while
charging. In balance mode, the battery needs to have the balancing lead connected to the balance
port on the right side of the charger. The power leads must also be connected to the positive and
negative terminals. Charging in this mode means the built-in processor monitors individual cell
voltage and controls the input current fed into each cell to equalise the voltage of that individual cell
with the others in the pack.
The left side on the first line shows the type of battery you chose. The
value on the left on the second line is the current. After setting the current
and voltage, press START/ENTER key for 3 seconds or more to start the
process. (Current: 0.1-5.0A Voltage: 3.7-22.2v)
This display shows the number of cells detected by the charger and the
number set manually by the user. "R" is the chargers reading. "S" is the
user set value, set previously. If both numbers are the same you can
start charging by pressing the START/ENTER Key. If not press
BATT.TYPE/STOP key to go back and amend if needed.
This screen shows the real time status during the charge process. Press
BATT.TYPE/STOP key once to stop the charge process.
18