HPI Racing reactor 500 Manuel D'installation page 18

Initial Parameter Setup (User Setup)
Key Beep ON
Buzzer ON
DEC INC
DEC INC
Input Power Low
Cut-Off 10.0V
DEC INC
Lithium (LiPo/Li-ion/LiFe) Program
This program is only suitable for the charging/discharging of Lithium(LiPo/Li-ion/LiFe) batteries with
a nominal voltage of 3.3/3.6/3.7v per cell. Different batteries have a different charge technique.
There are two methods, constant voltage and constant current. The charge current varies
depending on the battery capacity and specification. The final voltage is very important. It should
precisely match the voltage of the battery: LiPo is 4.2v, Li-ion is 4.1v and LiFe is 3.6v. The current
and voltage of the battery should be set correctly. When you want to change the parameters, press
START/ENTER key to make your selection blink then use DEC or INC to change the value. The
START/ENTER key will then confirm and store the value.
Key Beep is the sound that plays every time a button is pressed.
Buzzer is the sound that plays at various times during operation to confirm
different mode changes. These can both be switched ON or OFF
This function monitors the input voltage of the battery used to power
the charger. If the voltage becomes lower than the user set value, the
program will end forcibly to protect the input battery.
16