HPI Racing reactor 500 Manuel D'installation page 17

Safety Timer
ON 120Min
DEC INC
DEC INC
DEC INC
Capacity Cut-Off
ON 5000mAH
DEC DEC INC
INC
DEC INC
When a charge process starts, the integrated safety timer starts to run.
If an error is detected or the delta peak circuit can not detect whether the
battery has fully charged or not, this program will prevent overcharging.
Safety Timer Calculation
When charging NiCd or NiMH batteries, divide the capacity of the pack
by the charge current, then divide the result by 11.9 Set this number as
minutes for the value in the safety timer menu. If the charger stopped at
this time about 140% of the capacity will have been fed into the battery.
For Example:
Capacity Current
2000mAh 2.0A
3300mAh 3.0A
1000mAh 1.2A
This program provides a maximum charge capacity protection function.
If the delta peak voltage can not be detected and the safety timer has
not cut in, the charge process will stop automatically when the battery
reaches the user set maximum charge capacity.
15
Initial Parameter Setup (User Setup)
Safety Time
(2000/2.0=1000)/11.9=84 Minutes
(3300/3.0=1100)/11.9=92 Minutes
(1000/1.2=833)/11.9=70 Minutes