HPI Racing reactor 500 Manuel D'installation page 11

Please be aware of the following before commencing charging:
Has the correct program been selected for the type of battery you wish to use?
Did you set an adequate current for charging or discharging?
Have you checked the battery voltage? Lithium battery packs can be wired in parallel
and in series, 2 cell pack can be 3.7v (in parallel) or 7.4v (in series)
Have you checked that all the connections are firm and secure? Make sure there are
no intermittent contacts at any point in the circuit.
Charging
The Maximum charge current varies depending on the battery type or its performance,
and this information can be found in the manufacturers battery instructions.
Only batteries that expressly state they are capable of being quick charged are allowed
to be charged at higher rates than the standard charge current.
When connecting the battery pack to the charger: Red is Positive and Black is negative.
Always make sure that the connection leads are of an adequate conductive cross
section and that the connectors used are of high quality, normally gold plated. This
reduces the resistance and allows the charger to function correctly.
9
Warning and Safety Notes