Antari M-8 Mode D'emploi page 6

Setup
Remove all packing materials from shipping box. Check that all foam and plastic padding
․
is removed, especially in the nozzle area.
Place fog machine on a flat surface and remove the fog liquid tank cap.
․
Fill with high-quality, water-based fog liquid recommended by Antari dealer.
․
When filled, place cap back on liquid tank.
․
Firmly attach the M-21 control module cable to the connector inside the rear chamber for
․
the machine.
Operation
Plug power cord into a grounded electrical outlet. Turn the power switch to "ON" on the
․
back of the machine. Warm-up is completed when the display on the control module
shows "Ready to Fog"
To emit fog press the appropriate button on the M-21 control module for fogging duration,
․
interval and volume
The control unit display will display "Warming up" and "Ready to fog" as the machine
․
re-heats to the proper operating temperature.
For further information on operating your M-8 Fog Machine, see the section titled
․
"Control Module Operation"
The limited warranty is based on 8-hour operation per day. Exceeding usage may
․
shorten the lifetime of machines.
Caution
"Visibility during operation is reduced" This model can be operated at a floor level or sitting
on any regular surface. Whatever installation method you choose, do not allow the unit to
have more than a 35 degree angle of inclination.
6