Antari M-8 Mode D'emploi page 16

fog machine regularly can help you to reduce the frequency of parts replacement and
maintenance costs. After every 40 hours of continuous operation, it is recommended to use
distilled water to clean the heater according to the steps below.
The recommended cleaning steps is as followings:
1. Fill properly distilled water into a clean tank and connect the fluid tube of the fog machine
to the tank.
2. Run the unit in a well-ventilated area until the tank is almost empty.
3. Use a dry cloth to wipe the fog machine. Cleaning is now completed. Refill with fog liquid.
Run the machine briefly to clear any remaining liquid from the pump and heater.
Note: All fog machines are prone to clogging due to the thick consistency of fog liquid and
the high temperature at which it vaporizes. However, a properly maintained fog
machine should provide years of reliable use.
Clean with a dry cloth only. Store dry.
If the fog machine is not in use, please clean it before storage. Store the fog machine in a dry
and cool place. Operate the fog machine at least once a month. A test-run consists of
warming-up the machine followed by a few minutes of fog emission.
Please read and save these instructions.
16