Antari M-8 Mode D'emploi page 12

Setting Example 2:
In order to use 1 transmitter to control 2 or more machines, turn on the machines
respectively. When the displays indicates »Wireless Setup«, press the button "A" 1 second
on the transmitter within 15 seconds to establish the signal transmission.
-Battery change on the transmitter
If the range of the transmitter decreases, the battery is probably exhausted and must be
replaced. For this purpose, take off the housing cover and remove the used battery. Insert a
fresh DC 12V battery as indicated in the battery compartment and refit the housing cover.
Note: When warming-up process is completed and wireless function is activated the LCD
․
screen indicates "Ready To Fog W". ("W" means Wireless) On the contrary, when the
wireless function is deactivated the LCD screen shows "Ready To Fog" (Without "W").
DMX Connector Pin Assignment
The machine provides 3 or 5 pin XLR connectors for DMX connection. The diagram below
indicates pin assignment information
Pin
1
2
3
4
5
Function
Ground
Data-
Data+
N/A
N/A
12